Retrofit EPDM Pipe Boot Flashing (Round)
$19.50 – $31.50 USD
2 sizes (#1, #2)
- #1: 3/4″ to 2-3/4″
- #2: 2″ to 7-1/4” Pipes
Used For Going Around Electrical Poles Through Your Roof
Not Used For Single Wall Heat Pipes
Brand: Aztec Washer Company
$8 Flat Shipping on Pipe Boots. No Matter the quantity!
- The Standard Retrofit Master Flash® is designed to seal existing pipes/vents where a standard pullover flashing cannot be assembled.
- A simple solution to flashing a penetration through a metal roof that requires a wrap-around existing or hard to reach penetration Installation.
- 2 sizes (#1, #2)
- #1: 3/4″ to 2-3/4″
- #2: 2″ to 7-1/4” Pipes
- Made of Light Gray EPDM Rubber, for maximum resistance to ultraviolet light and ozone corrosion.
- It comes with a Stainless-steel clamp/gripper instead of many small rivets.
Additional Information:
Pipe Boot Size Chart (.pdf opens in new tab)- Click here
Aztec Washer Company Roof Pitch Calculator for Pipe Boot Model (opens in new tab)- Click here
Related products
-
Pipe Boot Flashings
SpringSeal Metal Roofing Pipe Flashing
$6.50 – $12.50 USD Select options This product has multiple variants. The options may be chosen on the product page -
Pipe Boot Flashings
High Temp Silicone Pipe Boot Flashings (Round)
$16.75 – $135.00 USD Select options This product has multiple variants. The options may be chosen on the product page -
Pipe Boot Flashings
Colored EPDM Pipe Boot Flashings (Round)
$7.50 – $20.00 USD Select options This product has multiple variants. The options may be chosen on the product page -
Pipe Boot Flashings
EPDM Pipe Boot Flashings (Non-High Temp) (Round)
$6.50 – $55.00 USD Select options This product has multiple variants. The options may be chosen on the product page